16049 Image IMAGE: laser power too high, check sensitivity Thermal Indicates the calculated laser power was above the limit for the current head type. Check that the correct media type was selected for the current image, and try the image again. If the error persists, call Creo Customer Support for help. Sensitivity-based wpower calculation is enabled and it shouldn't be. Make sure the "sys es" parameter is 0. If the sensitivity is supposed to be enabled, then the media sensitivity setting may be too high. ../nvs/sys_cfg_es.xmlNVS: sys es ../nvs/media_cal_sens.xmlNVS: media sens ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:30 2008 PST